Wilbur Curtis - SLG 10 Coffee Grinder

Description

Wilbur Curtis Single Low Profile Coffee Grinder. Take the “grind” out of grinding coffee beans with Curtis Portion Control Coffee Grinders. Available in Full-Size and Low-Profile Single Hopper and Dual Hopper models, these superior grinding systems feature fully automatic operation. A host of intelligent design features are incorporated to give you the most efficient, dependable and easy-to[1]operate coffee grinders you can buy.
FEATURES AT A GLANCE
-Fully Automatic Operation
-Solid State, Dual Range Timers - Ensures Precise Portion Control In All Portion Sizes
-Models Ilg & Islg “Interlock” With Gemini Systems - To Create A Foolproof Fresh-Grind/Fresh-Brew Coffee Center
Infinitely Adjustable Grind Settings - From Extra-Coarse To Extra-Fine Grinding
-Fully Adjustable Portion Size - 1 Oz. To 27 Oz. (20 Oz. On Ilg And Islg)
-Larger Hopper Capacity Than Competitive Models - Reduces Labor Costs With Less Frequent Refills
-Full-Size Models: Shg: Single 6 Lb. Hopper Dhg/Ilg:Dual 7.5 Lb. Ea. Hopper
-Low-Profile Models: Slg: Single 5 Lb. Hopper Islg:Single 5 Lb. Hopper
-One-Button Grinding - Automatically Stops When Portion Is Fully Distributed
DIMENSIONS:
Height (in.) 20.660”
Depth (in.) 8.000”
Depth (in.) 14.520”
ELECTRICAL:
Phase 1
Volts 120
Amps 8.0
Wire 2W+G
Watts 960
Hertz 60
Installation Requirements:
1. A secure surface capable of supporting the weight of the appliance.
2. For units without an attached cord set: Appropriately sized, UL listed, grounding type power cable to meet the electrical specifications for the appliance. If you have questions about the correct cable size and length, consult a qualified installer. If the unit will be hard wired to a junction box, the power cable must be long enough so that it can be moved for cleaning underneath.
3. A grounded electrical connection to an electrical circuit that meets the electrical specifications of the appliance (see SPECIFICATIONS). The circuit must be protected by the appropriate sized circuit breaker. If you are not certain that the existing circuit meets the requirements for your unit, consult a licensed electrician.
4. A water filtration system is required to maintain trouble-free operation.
5. Potable water supply line connection from the water filter capable of supplying the minimum flow rate required by the specifications. The water supply line must be able to connect to the flare fitting on the back of the unit. See the SPECIFICATIONS section for the correct size. The water line should also be capable of being controlled by a shut off valve. Do not connect the water line to a saddle or needle valve.